Pneumatic lifting rod has the advantages of large load, low noise, fast lifting, low seismic resistance, strong self falling buffer performance and stability
Attentions should be paid to the use of pneumatic lifting rod:
1. Before working, the air rod must be installed vertically with the working face.
2. Reasonable loading should be carried out according to the bearing capacity of the gas rod, and no overloading should be allowed.
3. The power source of the rod is compressed air (40 micron) dried after general filtration. A constant pressure relief valve of 0-2.5 kg/cm2 has been installed between the rod and the three-point combination (filtration, decompression, oil mist) to ensure the safe and stable lift of the rod. Do not exceed 3kg/cm2.
4. All seals are imported. The working temperature range is generally - 25 ~90 ~C. If special working conditions are required, please specify separately for customization.
5. The through-line lifting pole should pay attention to the insulation of the cable exposed outside the pole. If there is leakage, it should be repaired and used again.
6. Vehicle-mounted air pole can start up and down only when the vehicle is in a static state. It is strictly forbidden to use heavy objects to directly or indirectly impact the cylinder block of the air pole, otherwise it will cause adverse consequences.
| Performance parameters of pneumatic lifting mast | |
| model | GSD*8-120 |
| Initial height(m) | 2.35m |
| Lift height（m） | 12m |
| Node number | 8 |
| Inner diameter of the smallest tubule(mm) | Ø89 |
| Maximum Outer Diameter of Pipe（mm） | Ø256 |
| Vertical load（KG） | 160kg |
| Vertical load（KG） | ≤150kg |
| Working Pressure | ≤0.3Mpa |
| Wind resistance | ≤Level 8 |
| Product Material | Industrial Special Aluminum Alloy |
| colour（Optional） | silvery white |
